Tytan Fireblock 113 - Case of 12 Cans

TYTAN PROFESSIONAL Fire Block 113 meets or exceeds all fire block and draft stop standards. Fire Block 113 is not an approved fire stop sealant but is designed for the most extreme high heat and low humidity regions. Tytan Fire Block 113 offers industry-leading 113°F ambient and can temperature without shrinking and melting in the gap. Tytan Fire Block 113 is orange in color for easy inspection recognition and offers industry-leading expansion to fill and seal gaps in the most extreme conditions.

Applications

• filling free spaces, cracks, gaps, electrical boxes, gas line, wire and pipe penetrations
• wall and floor joints
• roofs
• ductwork
• wood
• metal
• mansory
• glass
• HVAC
• PVC
• plastics

Remarks / Restriction

Doors and Windows should be connected to structural framing according to the manufacturer's recommendations. Use of this product does not reduce the requirement of mechanical fasteners specified by window and door manufacturers. Water, Gas and Electrical Piping should always be properly secured to needed substrate with regulatory mechanical fasteners per building code. Fire Block foam sealant is safe for sealing and insulating on and around all PVC, metal and plastics water, gas and electrical piping. Always leave the can on the gun until a new can is needed to continue or start a new application. The can should only be removed when empty and a new can is needed to complete the same job. Ensure the control knob is tightened when the product is not in use. Air entering the barrel of the gun for more than 2-3 minutes will decrease the efficiency and life of your gun. The curing of the product is dependent on temperature and humidity. A significant decrease in temperature within 24 hours of application can affect the product's properties and adhesion. Use opened product within seven days. The product will not adhere to polyethylene, polypropylene, polyamide, silicone and Teflon. Quality and condition of the gun can impact the performance of the foam product. Uncured foam can be removed with TYTAN Foam Cleaner. Hardened foam may be removed mechanically (e.g. with a knife). For the safety of the installer, always ensure access to adequate ventilation during the application of polyurethane foams.